![]() ![]() Again tighten these in an X pattern to ensure the pressure is even resulting in a good mount on the CPU. The M4 screws will screw right into the mounting holes on the motherboard. The H70 Core cooling unit and retention ring can then be installed on the motherboard. The retention ring should then be put on the H70 Core. Then install the M4 screws through these holes. Make sure all of the holes on the retention ring are towards the outside (as seen below). Again socket 2011 uses larger M4 screws and does not need the backplate. The H70 Core uses the same bracket for socket 1155, 1156, 1366, and 2011. Tighten these in an X pattern to ensure the pressure is even, resulting in a good mount on the CPU. Install all four of the standoffs as shown below.Īfter installing and tightening down all four standoffs, the CPU cooler is ready to be installed. These are for socket 2011, the shorter end screws into the metal mounting plate on the motherboard. Included with the H80 and H100 are four standoffs that have a shorter wider end. Hydro Series H70, H80 and H100 CPU coolers all come with separate screws to mount on Socket 2011 boards. There is now a metal bracket that has been tapped to accept M4 screws. As you can see below there are no longer the traditional holes through the PCB. The new Intel® Socket 2011, used on the new X79 motherboards and the new 2nd generation Intel Core Sandy Bridge-E CPUs, has changed significantly from Socket 1366. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |